This system restricts the prediction using the parameters solubility and intestinal permeability. The solubility classification is based on a United States Pharmacopoeia (USP) aperture. The intestinal permeability classification is based on a comparison to the intravenous injection. All those factors are highly important because 85% of the most sold drugs in the United States and Europe are orally administered[citation needed].
Bcs Class Iii
Solubility class boundaries are based on the highest dose strength of an immediate release product. A drug is considered highly soluble when the highest dose strength is soluble in 250 ml or less of aqueous media over the pH range of 1 to 7.5. The volume estimate of 250 ml is derived from typical bioequivalence study protocols that prescribe administration of a drug product to fasting human volunteers with a glass of water.
Permeability class boundaries are based indirectly on the extent of absorption of a drug substance in humans and directly on the measurement of rates of mass transfer across human intestinal membrane. Alternatively non-human systems capable of predicting drug absorption in humans can be used (such as in-vitro culture methods). A drug substance is considered highly permeable when the extent of absorption in humans is determined to be 90% or more of the administered dose based on a mass-balance determination or in comparison to an intravenous dose.
For dissolution class boundaries, an immediate release product is considered rapidly dissolving when no less than 85% of the labeled amount of the drug substance dissolves within 15 minutes using USP Dissolution Apparatus 1 at 100 RPM or Apparatus 2 at 50 RPM in a volume of 900 ml or less in the following media: 0.1 M HCl or simulated gastric fluid or pH 4.5 buffer and pH 6.8 buffer or simulated intestinal fluid.
The BCS classifies orally administered immediate release drug products based on the fundamental principles that control the rate and extent of drug absorption, i.e., solubility, dissolution rate, and intestinal permeability. The categories are high solubility-high permeability (Class I), low solubility-high permeability (Class II), high solubility-low permeability (Class III), and low solubility-low permeability (Class IV) (14).
The surfactant vitamin E TPGS (d-α-tocopheryl polyethylene glycol 1000 succinate) has been classified as an inhibitor of P-gp-mediated drug transport in Caco-2 monolayers and other cell lines (58,59). It has also been shown to enhance the oral bioavailability of the BCS Class III drug colchicine in rats (60). Notably, in vitro findings involving intestinal absorption of P-gp substrates have been performed using Caco-2 monolayers, although these cells have variable P-gp expression based on the culture conditions (61) and it is indicated that they overexpress P-gp (62).
The Biopharmaceutics Classification System (BCS) classifies pharmaceutical compounds based on their aqueous solubility and intestinal permeability. The BCS Class III compounds are hydrophilic molecules (high aqueous solubility) with low permeability across the biological membranes. While these compounds are pharmacologically effective, poor absorption due to low permeability becomes the rate-limiting step in achieving adequate bioavailability. Several approaches have been explored and utilized for improving the permeability profiles of these compounds. The approaches include traditional methods such as prodrugs, permeation enhancers, ion-pairing, etc., as well as relatively modern approaches such as nanoencapsulation and nanosizing. The most recent approaches include a combination/hybridization of one or more traditional approaches to improve drug permeability. While some of these approaches have been extremely successful, i.e. drug products utilizing the approach have progressed through the USFDA approval for marketing; others require further investigation to be applicable. This article discusses the commonly studied approaches for improving the permeability of BCS Class III compounds.
The biopharmaceutics classification system (BCS) allows biowaiver for rapid dissolving immediate-release (IR) products of Class I drugs (high solubility and high permeability). The possibility of extending biowaivers to Class III high solubility and low permeability drugs is currently under scrutiny. In vivo bioequivalence data of different formulations of Class III drugs would support such an extension. The objective of this work was to demonstrate the bioequivalence of two marketed IR tablet products of a Class III drug, metformin hydrochloride, that are rapidly dissolving and have similar in vitro dissolution profiles. The effect of race on the systemic exposure of metformin was also explored. A randomized, open-label, two-period crossover study was conducted in 12 healthy Chinese male volunteers. Each subject received a single-dose of 500 mg of each product after an overnight fasting. The plasma concentrations of metformin were followed for 24 h. No significant formulation effect was found for the bioequivalence metrics: areas under concentration-time curve (AUC0-t, AUC0-infinity) and maximal concentration (Cmax). The 90% confidence intervals for the ratio of means were found within the acceptance range of 80-125% for the log-transformed data. Based on these results, it was concluded that the two IR products are bioequivalent. The pharmacokinetic parameters of metformin in Chinese for both products were similar and were in good agreement with those reported for metformin IR tablets in other ethnic populations. This study serves as an example for supporting biowaiver for BCS Class III drugs.
The Biopharmaceutical Classification System (BCS), which is a scientific approach to categorize active drug ingredient based on its solubility and intestinal permeability into one of the four classes, has been used to set the pharmaceutical quality standards for drug products in western society. However, it has received little attention in the area of Chinese herbal medicine (CHM). This is likely, in part, due to the presence of multiple active components as well as lack of standardization of CHM. In this report, we apply BCS classification to CHMs provisionally as a basis for establishing improved in vitro quality standards. Based on a top-200 drugs selling list in China, a total of 31 CHM products comprising 50 official active marker compounds (AMCs) were provisionally classified according to BCS. Information on AMC content and doses of these CHM products were retrieved from the Chinese Pharmacopoeia. BCS parameters including solubility and permeability of the AMCs were predicted in silico (ACD/Laboratories). A BCS classification of CHMs according to biopharmaceutical properties of their AMCs is demonstrated to be feasible in the current study and can be used to provide a minimum set of quality standards. Our provisional results showed that 44% of the included AMCs were classified as Class III (high solubility, low permeability), followed by Class II (26%), Class I (18%), and Class IV (12%). A similar trend was observed when CHMs were classified in accordance with the BCS class of AMCs. Most (45%) of the included CHMs were classified as Class III, followed by Class II (16%), Class I (10%), and Class IV (6%); whereas 23% of the CHMs were of mixed class due to the presence of multiple individual AMCs with different BCS classifications. Moreover, about 60% of the AMCs were classified as high-solubility compounds (Class I and Class III), suggesting an important role for an in vitro dissolution test in setting quality control standards ensuring consistent
The aim of this study was to compare the dissolution profiles of oral disintegrating tablets (ODTs) and immediate release (IR) formulations in order to experimentally validate the regulatory biowaiver scheme (BWS) for biopharmaceutical classification system (BCS) class III drugs. We examined six drugs that show clinical bioequivalence between the ODTs and IR formulations: taltirelin, olopatadine, droxidopa, famotidine, fexofenadine, and hydrochlorothiazide. The dissolution profiles of these drugs were evaluated using the compendium paddle apparatus at pH 1.2 and 6.8. Taltirelin and olopatadine showed very rapid dissolution and met the dissolution criteria in the BWS, whereas droxidopa, famotidine, fexofenadine, and hydrochlorothiazide did not. Furthermore, in the case of famotidine, fexofenadine, and hydrochlorothiazide, the ODTs and IR formulations showed dissimilar dissolution profiles. The dose-to-solubility ratio (D:S) of these drugs was larger than that of the other drugs. The results of this study suggest that extension of the BCS-BWS to ODTs and IR formulations of BCS class III drugs is appropriate. Furthermore, for BCS class III drugs with relatively high D:S, clinical bioequivalence would be achievable even when two formulations showed different dissolution profiles in vitro. Copyright 2014 Elsevier B.V. All rights reserved.
Esterification was used to simultaneously increase solubility and permeability of ciprofloxacin, a biopharmaceutics classification system (BCS) class 4 drug (low solubility/low permeability) with solid-state limited solubility. Molecular flexibility was increased to disturb the crystal lattice, lower the melting point, and thereby improve the solubility, whereas lipophilicity was increased to enhance the intestinal permeability. These structural changes resulted in BCS class 1 analogues (high solubility/high permeability) emphasizing that simple medicinal chemistry may improve both these properties.
It has been advocated that biopharmaceutic risk assessment should be conducted early in pediatric product development and synchronized with the adult product development program. However, we are unaware of efforts to classify drugs into a Biopharmaceutics Classification System (BCS) framework for pediatric patients. The objective was to classify five drugs into a potential BCS. These five drugs were selected since both oral and intravenous pharmacokinetic data were available for each drug, and covered the four BCS classes in adults. Literature searches for each drug were conducted using Medline and applied to classify drugs with respect to solubility and permeability in pediatric subpopulations. Four pediatric subpopulations were considered: neonates, infants, children, and adolescents. Regarding solubility, dose numbers were calculated using a volume for each subpopulation based on body surface area (BSA) relative to 250 ml for a 1.73 m(2) adult. Dose numbers spanned a range of values, depending upon the pediatric dose formula and subpopulation. Regarding permeability, pharmacokinetic literature data required assumptions and decisions about data collection. Using a devised pediatric BCS framework, there was agreement in adult and pediatric BCS class for two drugs, azithromycin (class 3) and ciprofloxacin (class 4). There was discordance for the three drugs that have high adult permeability since all pediatric permeabilities were low: dolasetron (class 3 in pediatric), ketoprofen (class 4 in pediatric), and voriconazole (class 4 in pediatric). A main contribution of this work is the identification of critical factors required for a pediatric BCS. 2ff7e9595c
Comments